Rique's Works

V.K

Starting XI
Делал ли ты в итоге пак рекламных щитов, которые Rique выкладывал по сезону 19-20, в формате rx3? Если есть rx3 файлы, скинь их, пожалуйста! / Please upload the rx3s if you have them
 

Johnny28ua

Starting XI
Делал ли ты в итоге пак рекламных щитов, которые Rique выкладывал по сезону 19-20, в формате rx3? Если есть rx3 файлы, скинь их, пожалуйста! / Please upload the rx3s if you have them
I don't remember exactly look at its pages
 

V.K

Starting XI
Rique is back! I'm telling a mfing friend.

I was just going to post a couple of feedback points, having installed and used lots of adboards by you.

1. I would suggest taking into consideration the fact that the single adboard used in the electronic mode will be duplicated on the right and on the left, and with that in mind it would be benefitial to make the edges transition smoothly between each other.

Examples (not necessarily your adboards ingame):



So if I may, my suggestion would be to take into consideration the sides of the adboards when it gets duplicated on both sides.



2. Following the same logic it would make sense to consider the spacing from the edges of the adboard and the spacing between objects when the adboard is duplicated.

E.g. from current Wolves adboard by you:


While ideally even spacing would be like this


With this method adboards look more uniform when they are duplicated alongside the whole lengh of the stadium:



Hope you don't mind my suggestions, looking forward to your works!
 

rique1984

Reserves
Rique is back! I'm telling a mfing friend.

I was just going to post a couple of feedback points, having installed and used lots of adboards by you.

1. I would suggest taking into consideration the fact that the single adboard used in the electronic mode will be duplicated on the right and on the left, and with that in mind it would be benefitial to make the edges transition smoothly between each other.

Examples (not necessarily your adboards ingame):



So if I may, my suggestion would be to take into consideration the sides of the adboards when it gets duplicated on both sides.



2. Following the same logic it would make sense to consider the spacing from the edges of the adboard and the spacing between objects when the adboard is duplicated.

E.g. from current Wolves adboard by you:


While ideally even spacing would be like this


With this method adboards look more uniform when they are duplicated alongside the whole lengh of the stadium:



Hope you don't mind my suggestions, looking forward to your works!
Thanks mate. The second example is simple to fix. The first few examples I will work on the gradient.
I am aware of that issue.
 

giuzioevo2

Youth Team


Top